6 -- REMOVING ECONOMIZER PISTON AND STEM ASSEMBLY
the idle adjusting needle (15) and spring (16). Discard the needle.
the venturi (13) out of the upper body casting.
the economizer piston and stem assembly (14) at the end with a pair of pliers
and pull the assembly out of the casting. Discard this assembly.
7 - REMOVING THROTTLE STOP LEVER PIN
of the throttle shaft for proper alignment during r,-assembly. Remove and
discard the two throttle plate screws (25). Slide the throttle plate (26)
out of the shaft.
the throttle lever clamp screw (17) and remove the throttle lever (18).
the pump link retainer (19) and slide the pump link (20) out of the pump
operating lever. Discard these parts.
the throttle stop screw (21) and spring (22).
out the pin (23) in the throttle stop lever with a punch having a diameter
no larger than 332". Remove the lever (24) from the throttle shaft.
lines on the upper surface of the throttle plate along both
(8) (9) (10)