Holley MCarbHoll2110 1957 Carburetor manual
Navigation bar
  Start Previous page  14 of 35  Next page End Home  

3. While holding the throttle kicker 
assembly back (Models 2110-EE and 2110-FF) 
separate the air horn assembly from the main 
body assembly. Remove and discard the carbu
retor body gasket.
4. Remove the two pump link retainers 
and lift out the pump link assembly.
5. Remove the three throttle body to 
main body screws and lockwashers, also the 
control rod bracket or the choke bracket. (Models 
2110-EE and 2110-FF)
6. Separate the main body assembly 
from the throttle body assembly and discard the 
throttle body gasket.
C.
DISASSEMBLY - THREE MAJOR SUB
ASSEMBLIES (MODEL 2110-G)
The following list contains all parts to 
be removed in separating the three major sub
assemblies. During disassembly discard all 
gaskets, also parts which have replacements in 
the Master Repair Kits.
Figure 3.
Disassembly - Major Subassemblies
Model 2110-G
1. Remove the five air horn to main 
body screws and lockwashers and identification 
tag.
Figure 4. Removing Air Horn Screws
2. Remove dashpot bracket and dashpot 
assembly - if included.
3. Separate the air horn from main 
body and discard the gasket.
4. Remove pump cotter pin and pump 
link assembly.
5. Remove the three throttle body to 
main body screws and lockwashers.
6.
Separate the main body from
throttle 
body and discard the gasket.
Previous page Top Next page